moderated Re: Scanning a document in K1000 and Open Book


Mario
 

a slight correction and some other info:

when pressing numpad 6, make sure the numpad is set to the reading
keypad (insert+numpad - (it's a toggle that cycles)). to save the
configuration, press alt+t and then v and enter if there's only the
default configuration. you can setup (I don't know if there's a limit)
custom configurations taylored to your needs. you can switch to a custom
configuration manually after starting K1000 (alt+t and then l, arrow to
the configuration name and enter). I don't know if there's a way to
automatically load a custom configuration instead of K1000 starting with
the default configuration.

-------- Original Message --------
From: Mario [mailto:mrb620@...]
To: main@jfw.groups.io <main@jfw.groups.io>
Date: Sunday, September 15, 2019, 11:59 AM
Subject: Scanning a document in K1000 and Open Book
in K1000, numpad 6 will toggle between column identification between
being enabled or disabled. toggle it to disabled. if you want, don't
forget to save the configuration so the setting persists.

-------- Original Message --------
From: tom x [mailto:ballistic719@...]
To: main@jfw.groups.io <main@jfw.groups.io>
Date: Saturday, September 14, 2019, 5:26 AM
Subject: Scanning a document in K1000 and Open Book
Hi,

Does anyone know if there is a setting which can be altered in the
latest versions of either K1000 or Open Book so that the display on the
screenor the saved document matches the layout of the original material?

I need to scan some technical material and have the result match the
layout of the original document.Currently the lines are joined and all
over the place which is vastly different from the original document.

Can anyone help?

Thanks

Tom






.

Join main@jfw.groups.io to automatically receive all group messages.